Vauxhall Corsa D Steering Column
The Delphi steering column used in the Vauxhall Corsa D uses a variety of part numbers depending on: the year, engine option, and model variant.
But many of the part numbers relate to one of 2 or 3 different columns and many of these will interchange.
From 2010 onwards Delphi modified the Corsa d column and put the torque sensor cable inside the unit, this means that on later Corsa d models there are only two electrical plugs visible.
In truth nearly all 3 plug and 2 plug columns will interchange and work exactly the same, there are a few exceptions such as the Corsa VXR and the Ecoflex model, in general, we do always try to supply like for like by identifying from your vehicle reg. which type of column you have.
The Corsa D E.P.S steering system is flawed and prone to either intermittent or total failure.
Common Fault Codes will be;
C0460: steering position sensor plausibility
C0545: steering torque sensor circuit
C0545: steering torque sensor plausibility
Any of these faults will require a replacement column.
1. Motor failure, sometimes intermittent to begin with but always leads to terminal failure, due to components within the internal control board inside the motor burning out.
2. E.C.U. Failure, the ECU contains several chips which control both function of the column and also the self-test and failure system. One or more of these chips can fail and cause the system to shut down, sometimes the ECU can give an erroneous fault code that appears to be a motor failure if scanned, but is actually a fault of the ECU itself. Importantly the ECU also controls the left/right balance of the column and is used to calibrate the output from the torque/position sensor contained in the column, for this reason, the ECU should be matched and calibrated to the torque sensor.
3. Torque and position sensor. This is inbuilt into the centre of the column and gives the ECU information on the position of the steering wheel and also how much assistance is required from the motor. The sensor can go out of balance and steering becomes lighter in one direction, also can fail to give the signal, which will cause ECU to shut the system down. When a torque sensor is replaced the column needs to be re-calibrated to ensure it is in balance. We believe the only way to do this is for us to supply a complete column with all components tested and calibrated.